First, make sure the drywall edges are well fastened to the. one gallon of glue goes a long way so it isn't expensive. You can use the same patching compound to handle wide gaps between adjoining sheets of drywall. I know using glue isn't "normal" but it works well for me so that's how I choose to do it. I know tradesmen usually just slap on some taping mud, then use a taping knife to set the tape and leave some material in which to build upon, then start the filling process. As mentioned with the V grooving, a mixture of some glue in the mud may help to fill in the deep voids. The contractor might be right in that you should allow time for any movement to occur, perhaps you can go around and fill any deep voids and cracks and allow your material to shrink and dry, below the tape. It works well for me and I dont see any of the taping I have done peeling or bubbling or cracking. It is more work this way and must be done in stages with some dry time. I have seen a lot of tape applied by contractors bubble and by using carpenters glue, it dries a whole lot tougher. i sometimes will mix a little white carpenters glue with the mud, You can't sand the stuff if you do, so you have to make sure it stays level, I guess sheetrock 90 might be similar, haven't tried that.Īlso when taping, I run the paper tape through carpenters glue diluted about 50/50, and I mix a little glue into the mud I use for taping.įinally when the walls are close to flat, then I use a sandable mud. I like to fill any large gaps so they are level before taping.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |